Reeds 'n Stuff Spare Blade 360° for Profiling Machines
After years of development, Reeds 'n Stuff is proud to offer the Blade 360°. When the blade becomes dull simply rotate to the next sharp section and continue profiling. This can be done at least 6 times, providing reeds and reeds of profiling before a replacement blade is needed.
The screw holding the blade is easily accessed from the underside, meaning once the height of the blade holder is set, you can set it and forget it. Simply loosen the screw, rotate the blade, and re-tighten the screw. Within seconds you can continue profiling reeds, rather than having to replace the entire blade.
-
-
To rotate the blade, first loosen the screw on the underside of the blade holder with the attached screwdriver.
-
-
Carefully rotate the blade to the next desired position.
-
-
Hold the blade in place while tightening the screw with the provided screwdriver and you are ready to profile.
Note: be sure not to over-tighten the screw holding the blade. Due to its small size it is possible to damage the screw and/or screwdriver in this manner.
No one has reviewed this product! Write a Review
